Overview

The roof drip moldings run along both sides of the roof on the 1996-2000 Civic 3-door hatchback, capping the joint between the roof panel and the glass. On a car this age they are usually the originals: the rubber hardens in the sun, the edges lift, and the strip pulls back from the ends. Once it lifts, rain and car-wash water work into the roof channel and wind noise shows up at highway speed. This AUXITO pair replaces both sides at once, in black.

Vehicle fitment & specifications

Features

Rubber that resists aging
Made of rubber with anti-aging properties, so the strip stays flexible through sun and temperature swings instead of hardening and shrinking back.

Direct replacement
Shaped to the original molding, so it seats along the roof edge the way the factory piece does.

Checked before packing
Every pair is tested before it ships, so what arrives matches the fitment parameters listed for your vehicle.

Fitment check

This set is listed only for the 1996-2000 Civic 3-door hatchback in CX and DX trim — the 4-door sedan, coupe and higher trims use different roof trim. Note the transmission/plant codes in the table above vary by year (1996-1997 also list KL 4AT/5MT), so check your year's line and compare the number on your original molding against the OE list before ordering.

What's in the box

• 2 roof drip moldings: left and right

FAQ

Will this fit my 4-door or coupe Civic?
No — this set is listed for the 1996-2000 Civic 3-door hatchback (CX, DX) only. The sedan and coupe of these years use different moldings.

Are both sides included?
Yes. The set is two moldings, one for each side of the roof.

Are clips included?
Yes — as shown in the product photo, each molding comes with its end clips fitted, so the pair is ready to seat into the roof channel.

How do I confirm I have the right one?
Match the number on your original molding against 74306-S03-003 / 74316-S03-003, and check your year and trim against the fitment table.